I'm still waiting on my chrono to turn up, but it's in the UK so shouldn't be long. If not, I'd bite the BB and change that spring for a known quantity. Have you spooged any silicone up the nozzle? That might be enough to get a better seal. 0.67J, even TM fanbois would have a hard time justifying that. Urgh, that's weaker than a politician's excuse. It'll get replaced anyway when my Novritsch modular one turns up, complete with camo cover for a different look. And I noticed when trying the flash hider back on my slightly mangled thread that it's (now?) quite loose, so that grub screw is important - don't lose it!Īnyway the result is rather nice, though the finish is a little too shiny, i might rough it up with a brillo pad or some polishing paper. so do take care when fitting your tracer (of course, if it's a reputable make it might only go on 'properly'). I fitted the suppressor and managed to chew up some of the thread as it's quite fine and very soft and my first attempt wasn't quite done right. I had no problem with the grub screw, and no problem with the flash hider either. but a little before that I'd ordered a cheapo one from AliExpress, and it's just turned up! So I had good reason to take the flash hider off mine. ![]() The suppressor I was talking about is a Novritsch one that I ordered on Black Friday. I've not had to take my handguard off, so maybe I've missed something! Also - I can access the grub screw without doing that (which is nice) - I'll be needing to do that as I've got a suppressor on the way. ![]() I think you just loosen that off to detach the handguard from the top receiver.Īnd there's a small hex bolt at the front end of the handguard that also needs undoing. ![]() On my 906C there's a small hex bolt on a thread that you can see through a slot in underside of the handguard, close to the receiver.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |